Banks Power Ford Trucks: (Diesel ’99 - 03 7.3L Power Stroke) Power Systems- Stinger, Stinger-Plus & PowerPack systems '19991_2-2003 F250_F350 Trucks & Excursion (non-cat) - Manual (Page 9)

29.
Position all the exhaust
components such that all the hanger
pins are parallel with the frame pins
and all exhaust tubing is located
properly. Lightly tighten the clamps
to maintain position. The tailpipe tip
should be positioned 1-1 1 ⁄ 2 ” below
the bottom edge of the fender. All
hangers should be hanging slightly
forward to allow for heat expansion
of the exhaust tubing (see Figure 6).
30.
With everything positioned
properly, begin to tighten the clamps
starting with the ones closest to the
turbo and working your way back.
For Git-Kit installation, proceed to
Step 77.
For Stinger installation, proceed to
Step 62.
For Stinger-Plus installation,
proceed to Step 53.
For PowerPack installation,
continue with Step 32.
–END, SECTION 4–
Figure 4
Figure 6
96334 v.5.0
9