Banks Power Chevy_GMC Trucks: Duramax LML (Diesel ’11 - 14 6.6L) Intake- Ram-Air Super Scoop '11-13 - Manual (Page 14)

14
96556 v.2.0
31.
Make sure that the Super-Scoop is in a position that
does not interfere with the chassis frame, bumper support,
wire harnesses, wheel well liner, or any other components.
: If the Super Scoop is not positioned
properly it will interfere with the wheel or wheel
well liner. Make sure there is adequate clearance
between the Super-Scoop and wheel at all extreme
positions of the wheel. (Full steering and suspension
travel).
32.
Position the fender well liner into the wheel well. Attach
the previously removed wire harness to the fender well liner.
Install the fender well liner and secure it using the previously
removed plastic retaining pins.
: When installing the fastener to the cut
Wheel liner support bracket make sure that it is
fastened to the support bracket.
34.
Take a measuring tape and place over the wheel liner as
shown in figure 33. Measure 2” from the bottom of wheel
liner and 9” from the bumper edge. Mark that location.
35.
center punch the marked location and drill a pilot hole
through the liner and into the Banks Super-Scoop with a 1/8”
drill bit. Finish drilling with a 1/4”drill bit.
36.
Locate a supplied push in retainer and insert into the
drilled hole. Push in the center of the retainer to fasten it.
See figure 34.
: Make sure the wheel well liner is secured to
the Banks Super-Scoop.
37.
You have now successfully installed the Banks Super-
Scoop to your vehicle.
figure 33 figure 34