Banks Power Chevy_GMC Trucks: Duramax LML (Diesel ’11 - 14 6.6L) Intake- Ram-Air Super Scoop '11-13 - Manual (Page 12)

12
96556 v.2.0
23.
Re-install the Ram-Air Housing following Banks
Ram-Air installation manual.
24.
Install the Banks Super-Scoop from beneath the
front bumper and place the Super-Scoop’s opening over
the bottom of the Banks Ram-Air housing down spout.
See figure 22. Place the upper bracket slots over the
threaded studs on the middle bracket. Locate the supplied
washer and nylock nuts and fasten the upper bracket to
the lower bracket till snug.
25. Install the supplied bolts and washers through the
Super-Scoop holes attaching to the clip-On-Nuts on the Ram-
Air Housing, see figure 23. Hand tighten the bolts.
: Clip-On-Nuts are self locking and will not
allow the bolts to spin freely.
26. For MY07-10 2500, go to the inlet of the Super-Scoop
and align the inlet to fit the contour of the bumper. See
figure 24 and figure 25.
figure 24
figure 25
figure 22
figure 26
figure 23