Velleman CAMIP9 - Manual (Page 3)

CAMIP9
V. 02 – 25/06/2012 3 ©Velleman nv
5. Installation
Note: The installation method below describes the setup for iPhone ® with a D-Link ® wireless router and
modem. The installation procedure is similar for iPad ® or Android™ devices. Refer to the full manual on
the included CD ROM for more information.
5.1 Assembly
1. Fasten the round base of the bracket to where you want to install the camera. The distance between
your camera and the location you want to monitor should be 2~3 metres.
2. Assemble the bracket and the camera [8], and adjust the viewing angle of the camera.
3. Plug the included power adapter into the camera [6] and connect it to a power socket.
5.2 Preparing the Network Configuration
We recommend that you use your own ADSL or cable internet service for easy network configuration.
10 CAMIP9
11 network cable 8P8C (RJ45)
12 mobile device (iPhone, iPad…)
13 LAN port
14 wireless router
15 WAN port
16 modem
1. Connect your camera [10] to your wireless router [14] using the included network cable
[11->13].
2. Make sure the LAN status indicator on the camera is on (not blinking). If not, check the
connection with the network cable, and make sure the camera is powered on.
3. If you haven’t done so already, install the EagleEyes-Lite or EagleEyes-Plus app on your mobile
device [12]. You can download the app from your device’s app store.
4. Optional: if your wireless router supports UPnP, make sure the function is enabled.
5. Write down the IP address of your wireless router. You will need it later. To find the IP address,
proceed as follows:
6. Connect your mobile device to the wireless
router that has the camera connected.
7. Go to Settings > WiFi.
8. Press the “>” button to see the details of the
selected wireless network.
The IP address is visible next to “Router”.
(In the sample screen, the IP address is
192.168.2.1)
5.3 Configuring the Network
1. Connect your mobile device to the wireless router that has the camera connected.
2. Open the EagleEyes app and click the “+” button to add a new device.
3. Select “Local Network Search” to search for the camera.