Velleman CAMIP12 User manual User Manual

Page 5

CAMIP12

V. 00 – 23/03/2012

©Velleman nv

Preparing the network configuration

1. Connect your camera to your wireless router using the included RJ45 network cable (see Network

setup above).

2. Write down the IP address of your wireless router. You will need it later. To find the IP address,

proceed as follows:

3. Connect your mobile device to the wireless

router that has the camera connected.

4. Go to Settings > WiFi.
5. Press the “>” button to see the details of the

selected wireless network.

The IP address is visible next to “Router”.
(In the sample screen, the IP address is
192.168.2.1)

Adding your camera to the EagleEyes app

1. Establish a wireless connection between your mobile device and the wireless router that has the

camera connected.

2. Open the EagleEyes app and click the “+” button to add a new device.

3. Select “Local Network Search” to search for the camera.

The device will show a list of devices on the network.

The displayed IP address is the address that your
router assigned to your camera.

If the camera is not in the list, make sure the LAN

status indicator on the camera is on (not blinking).

Reset the camera with the Reset button if necessary.
Wait for 3 minutes and then use “Local Network
Search” again.

4. Select the camera from the list. The settings page appears.
5. Change the port number of the camera as needed. The default port number is 88. If port number 88

is blocked, you can change it to any value from 1~9999 (for example 8080).

6. Write down the IP address and the port number of the camera. You will need them later.

(In the sample screens below [A], the IP address is 192.168.2.197 and the port number is 88.)

7. Press “Apply” to confirm your settings.
8. Wait until “Status” [B] indicates “Done” or “Fail”.

If the status shows “Done”, the device page appears again. Proceed with the next step.

If the status shows “Fail”, press the

button on the top right side of your device. In the

popup window, select “DDNS”. The device page appears again. Proceed with the next step.