beautypg.com

Software configuration – Velleman CAMIP12 User manual User Manual

Page 4

background image

CAMIP12

V. 00 – 23/03/2012

4

©Velleman nv


6. Installation: Power supply and POE (power over Ethernet) connection

You can choose between a power supply or POE (power over Ethernet).
a.

Power supply

For your camera to work properly, you need to connect the camera cables as follows:

Connect the network cable to your network.

Plug the camera’s power cable in the included power adapter and connect it to a power socket.


b.

POE (Power over Ethernet) connection

The camera features POE (Power over Ethernet). If your router or hub supports POE, you do not need to

connect the camera to a power socket. You can then connect the camera as shown below:

8

POE router / hub

9

LAN cable

10

Camera

11

Power

Use a network cable [9] to connect your camera [10] to a POE port of your router [8].

Make sure your router is connected to a power socket [11].


Note – If your router does not support POE, you can use a POE injector (not included) to use the POE
feature.

7. Software configuration

The installation method below describes the setup with an iPhone

®

with a D-Link

®

wireless router and

modem. The installation procedure is similar for iPad

®

or Android™ devices. Refer to the full manual on

the included CD ROM for more information.
a.

Prerequisites

Before proceeding, check the following:

We recommend that you use your own ADSL or cable internet service for easy network configuration.

Your camera is connected to your wireless router with a RJ45 network cable, and it is powered on.

EagleEyes-Lite or EagleEyes-Plus is installed on your device.
If not, download it from your device’s app store.
Note: EagleEyes HD for iPad does not support network configuration. Please install EagleEyes-Lite or

EagleEyes Plus on your iPad instead.

8

11

9

10