Velleman CAMIP12 User manual - Manual (Page 3)

CAMIP12
V. 00 – 23/03/2012 3 ©Velleman nv
b.
Connectors
The camera has the following connectors:
c.
Network setup
1 Mobile device
2 LAN port
3 Wireless router
4 WAN port
5 Modem
6 Network cable (RJ45)
7 CAMIP12
5. Installation: hardware
You can install the camera as follows:
1. Separate the dome cover from the camera.
2. Make sure the screw holes on the plate are aligned with the holes on the camera base.
If not, slightly loosen the two screws on the plate and rotate it.
3. Mark the locations of the two screw holes on the ceiling, and drill a hole for each on the ceiling.
The distance between your camera and the location you want to monitor should be 3 ~ 4 meters.
4. Fix the camera to the ceiling with the supplied screws.
5. Adjust the position and viewing angle of the camera, and fasten the two screws on the plate to fix.
6. Replace the dome cover back to the camera.
1 Loosen to remove dome cover
2 Loosen slightly to rotate plate
3 Screw hole
1
2
3
1
4
2
3 5
1 Audio connector
2 Reset button
3 Network connector
4 Alarm in/out connector
5 Power adapter connector