beautypg.com

Step 1 - open the touch panel, Step 2 – disconnect the connector cable, Step 3 - choose a wiring method – Velleman LEDC14 User Manual

Page 4: Step 4 - attach the controller on the wall

background image

LEDC14

V. 01 – 28/03/2013

4

©Velleman nv

 The supply voltage of the controller ranges between

DC12V~DC24V. Using other voltages will damage the controller.

Step 1 - Open the touch panel
 As shown, gently open the touch panel (for example with a small

screwdriver).

Step 2 – Disconnect the connector cable
 Open the connector and gently remove the connector cable.

Step 3 - Choose a wiring method
Connect the wires according to the mode you will use (see section
Wiring below).
Step 4 - Attach the controller on the wall
Attach and screw the controller to the wall as shown in the picture.
The distance between the screws is 60mm.

See also other documents in the category Velleman Lighting: