Velleman VDPC130 User Manual

Page 5

VDPC130_v3

VELLEMAN

The DMX starting address should be assigned every 16 channels. Address every projector to the respective starting
address otherwise the channel assignment will not be correct. Projectors with the same starting address will work

synchronous.

g. Channel Setting

This device can control up to 12 x 16-channel scanners. The first 8 channels of each scanner can be controlled
through the 8 faders. The next 8 channels are controlled through the 8 faders and the PAGE selection button (10) on

page B.

If the scanner features more than 16 channels, set the channels as follows:

• Press the PROGRAM button (11) until the LEDs blink.

• Press the FINE (25) and the MODE (28) buttons simultaneously until the ASSIGN LED (20) turns on.

• Select your scanner by pressing the corresponding SCANNER button (1).

• Adjust the SPEED fader (23) to select the scanner channel (e.g. channel 9 or 10).

• Adjust the FADE TIME fader (24) to select the respective control channel of the controller (e.g. PAN (27A) or TILT

(27B) wheel).

• To set channel 19 and 20, press the PAGE selection button (10). The PAGE B indicator LED (9) will light. Repeat

the two previous steps.

Example: Set the SPEED fader (23) to channel 9 and the TIME fader (24) to X. This means the 9

channel of the

scanner will be controlled by the PAN wheel (27A).

h. FADE TIME Assignment

With this function you can determine whether the fade time should be assigned to the pan/tilt movement or to all

DMX channels. This is useful when the mirror or the moving head movement should be carried out slowly but the
gobos and colours should be changed quickly.

• Turn of the device.

• Simultaneously press and hold the MODE (28) and the TAP DISPLAY button (17).

• Turn on the device. Press the TAP / DISPLAY button (17) in order to switch between the two modes (ALL CH for

all channels and ONLY X/Y for pan/tilt movement only).

• Simultaneously press and hold the MODE (28) and TAP / DISPLAY button (17) to memorise your settings. All

LEDs on the panel will flash indicating the setting has been saved.

6. Operation

a. Manual Mode

To select the manual mode, press the AUTO / DEL button (21) until the MANUAL LED (14) lights.

In manual mode you can call up the connected scanners manually and control them through the faders. Note that the
settings cannot be memorized.

Select the desired scanner using the corresponding SCANNER button (1). Adjust the desired function through the

faders.

• Checking a BANK / SCENE

Select the desired bank using the BANK buttons (16 and 17). Select the desired scene using the SCENE buttons
(3).