Velleman VDPLPS3612B - Manual (Page 5)

VDPLPS3612x
03.03.2011 5
7. Operation
• Set the desired mode using the mode button [1A]. The mode is indicated in the display (refer to the table
below).
• Change the setting with the UP [1B] or DOWN [1C] buttons.
display mode setting from
DMX see table below -
sound controlled sensitivity max.
red (R)
brightness off
green (G)
blue (B)
R + G
R + B
B + G
R + G + B
black out all LEDs off -
R +G + B flash
speed fast
7 colour change
7 colour flash
7 colour fade
DMX address
• When using DMX mode ( ), first set the DMX address.
• All DMX-controlled devices need a digital start address so that the correct device responds to the signals.
This digital start address is the channel number from which the device starts to “listen” to the DMX
controller. The same starting address can be used for a whole group of devices or an individual address can
be set for every device.
• When all devices have the same address, all the units will “listen” to the control signal on one particular
channel. In other words: changing the settings of one channel will affect all devices simultaneously. If you
set individual addresses, each device will “listen” to a separate channel number. Changing the settings of one
channel will only affect the device in question.
• In case of the 5-channel VDPLPS3612X, you will have to set the start address of the first unit to 1
(CH1~5), the second unit to 6 (1 + 5) (CH6~10), the third to 11 (6 + 5) (CH11~1
DMX mode ( )
CH1
(mode)
function CH2
(speed)
CH3
(red)
CH4
(green)
000 ~ 025 Black out - - -
026 ~ 050
R, G, B 000 ~ 255
dimmer
000 ~ 255 000 ~ 255
051 ~ 100
flash 000 ~ 255
slow ~ fast
000 ~ 255
brightness
000 ~ 255
brightness
101 ~ 150
7 colour change 000 ~ 255
slow ~ fast
- -
151 ~ 200
7 colour fade 000 ~ 255
slow ~ fast
- -
201 ~ 240
sound controlled 000 ~ 255
slow ~ fast
- -
241 ~ 255 full R, G, B - - -
• To use slave mode, first connect the devices as described in §6b.
• On all slave devices set the mode to .
©Velleman nv
. The mode is indicated in the display (refer to the table
to
-
max. min.
max.
-
fast slow
controlled devices need a digital start address so that the correct device responds to the signals.
This digital start address is the channel number from which the device starts to “listen” to the DMX
can be used for a whole group of devices or an individual address can
When all devices have the same address, all the units will “listen” to the control signal on one particular
channel will affect all devices simultaneously. If you
set individual addresses, each device will “listen” to a separate channel number. Changing the settings of one
ss of the first unit to 1
11~15), and so on.
CH4
(green)
CH5
(blue)
-
000 ~ 255 000 ~ 255
000 ~ 255
brightness
000 ~ 255
brightness
-
-
-
-