Atdec Telehook TH-PS-D Installation manual - Manual (Page 2)

Slide the hook on the Support
Arm over the top bolts on the
Wall Plate.
Swing the Support Arm down so
the bottom slots slide over the
bottom bolts.
The Support Arm can be
adjusted by +/- 5° to account
for wall slope or individual
projector characteristics.
Adjust the stop bolt as
shown to maintain the
desired angle.
Secure the position of the Support
Arm by tightening the two bolts on
each side of the Wall Plate.
LH
5.1. Remove screw from End Cap and slide End Cap off
5.2. Loosen screws on Sliding Pole Mount and slide the entire assembly off
5.3. Slide off Base Cover
5.4. Slide the Cable Cover out
Step 4. Insert Covers and Extrusion onto Wall Plate
Step 5. Remove End Cap, Sliding Pole Mount, Base Cover and Cable Cover from Support Arm
Step 6. Attach Support Arm to Wall Mount
RH
Cable Cover Base Cover Sliding Pole Mount End Cap
+5°
-5°
6.1.
6.3.
6.4. 6.5.
6.2.
Extrusion
Cover
Installation Instructions