VEGA VEGAPULS 62 (≥ 2.0.0 - ≥ 4.0.0) standpipe ver. Profibus PA - Manual (Page 13)

13
3 Product description
VEGAPULS 62 standpipe version • Profibus PA
36509-EN-121011
It is suitable for measured value indication and adjustment of plics ®
sensors and is connected to the sensor with a four-wire standard
cable up to 50 m long.
You can find further information in the operating instructions "VE-
GADIS 61" (Document-ID 27720).
The PLICSMOBILE T61 is an external GSM/GPRS radio unit for
transmission of measured values and for remote parameter adjust-
ment of plics ® sensors. The adjustment is carried out via PACTware/
DTM by using the integrated USB connection.
You can find further information in the supplementary instructions
"PLICSMOBILE T61" (Document-ID 36849).
Screwed flanges are available in different versions according to the
following standards: DIN 2501, EN 1092-1, ANSI B 16.5, JIS B 2210-
1984, GOST 12821-80.
You can find additional information in the supplementary instructions
manual "Flanges according to DIN-EN-ASME-JIS" (Document-ID
31088).
The protective cover protects the sensor housing against soiling and
intense heat from solar radiation.
You will find additional information in the supplementary instructions
manual "Protective cover" (Document-ID 34296).
The electronics module VEGAPULS series 60 is a replacement part
for radar sensors of VEGAPULS series 60. There is a different version
available for each type of signal output.
You can find further information in the operating instructions "Elec-
tronics module VEGAPULS series 60" (Document-ID 36801).
External radio unit
Flanges
Protective cover
Electronics module