VEGA EL 1 Conductive probe - Manual (Page 13)

Fig. 6: Component for line break monitoring in conjunction with VEGATOR 632
1 Open the terminal of the measuring rod and attach the component.
2 Connect the eyelet according to the following illustration.
Make sure that the eyelets have no contact to other metal parts.
3 Tighten the terminal.
Fig. 7: Mounting of the component for line break monitoring
1 Connection to terminal 1 (ground terminal)
2 Connection to terminal 2 (measuring rod)
3 Component for line break monitoring with VEGATOR 632
If you are using a probe without component for line break monitoring, a
fault signal will be triggered.
Keep in mind that in case of a fault signal also the switching output will
be activated.
Only failures of channel 1 are monitored.
Conductive probe EL 1 13
5 Connecting to power supply
32651
-
EN
-100208