VEGA PLICSRADIO R61 Wireless indicating unit - Manual (Page 15)

15
5 Connecting to power supply
PLICSRADIO D61 • Wireless indicating unit (single channel)
32626-EN-130228
Fig. 9: Connection steps 6 and 7 (connect voltage supply)
9. Press down the opening levers of the terminals, you will hear the
terminal spring closing
10. Check the hold of the wires in the terminals by lightly pulling on
them
11. Tighten the compression nut of the cable entry. The seal ring must
completely encircle the cable
12. Insert and screw terminal cover
13. If a display and adjustment module is installed, insert it by turning
it slightly to the right.
14. Screw the housing cover back on
The electrical connection is hence finished.