VEGA PLICSRADIO T61 Wireless emitting unit - Manual (Page 22)

22
6 Set up with the display and adjustment module
PLICSRADIO T61 • Wireless emitting unit (single channel)
32865-EN-130322
the operating instructions of the respective instrument. Take note that
the HART sensor must be provided with HART address 0 or 1.
After being switched on, PLICSRADIO T61 first of all carries out a
short self-check. The following steps are carried out:
•
Internal check of the electronics
•
indication of the instrument type, firmware version as well as the
instrument TAG (instrument name)
•
Enquiry of the sensor input
•
Establishment of a radio connection
The measured value indication displays the digital indication value,
the measurement loop designation (measurement loop TAG) and the
unit. The actual signal strength can be also displayed. By pushing the
[>] key, you move between the individual indicating windows.
1. By pushing [OK] you move from the measured value indication to
the main menu.
2. Select the menu item "Device settings" with [->] and confirm with
[OK].
You can assign an unambiguous name to PLICSRADIO T61 via the
Device-TAG. This function is recommended when several instruments
are implemented and a good documentation of larger systems is
required.
→
Enter the requested values via the appropriate keys and save
your settings with [OK].
The emitting and receiving units must be always set to the same radio
channel. When using several independent radio links, each radio link
must be provided with a different channel. In total, seven radio links
are available (channel 0 … 6).
→
Enter the values via the appropriate keys and save your settings
with [OK].
Switch-on phase
Measured value indica-
tion/Main menu
Device settings - Device-
TAG
Device settings - Radio
channel