VEGA VEGAWAVE 63 - two-wire - Manual (Page 20)

6 Set up
6 .1 General information
The figures in brackets refer to the following illustrations.
On the electronics module you will find the following indicating and
adjustment elements:
l Potentiometer for adaptation to the product density (1)
l DIL switch for mode adjustment - min./max. (2)
l Signal lamp (5)
Note:
As a rule, always set the mode with mode switch (2) before starting the
setup of VEGAWAVE 63 . If the instrument is used in conjunction with
a signal conditioning instrument, always set the mode switch (2) on
VEGAWAVE
63 to max. mode.
The mode is selected on the signal conditioning instrument with the
mode switch.
The switching output will change if you set one of the two mode
switches afterwards. This could possibly trigger other connected
instruments or devices.
Function/Configuration
20 VEGAWAVE 63 • - two-wire
6 Set up
32260
-EN
-120418