VEGA VEGAFLEX series 60 - External housing - Manual (Page 6)

The electrical connection must be carried out on the instru-
ment housing.
The instrument housing consists of a base body, the screwed
cover for the electronics or connection compartment and the
housing socket.
Depending on the order, the screwed cover of the instrument
housing is available with or without inspection window for the
indicating and adjustment module PLICSCOM.
The HF connection cable of the external housing can influence
the measurement properties of VEGAFLEX. When the length
of the sensor exceeds the length of the HF connection cable,
then the the min. dielectric figure is ε
r
> 2 independent of the
instrument version. If the HF connection cable is longer, there
are no limitations.
3 .2 Principle of operation
The external housing is suitable for the following plics sensors:
l
VEGAFLEX 61
l
VEGAFLEX 62
l
VEGAFLEX 63
l
VEGAFLEX 65
The external housing cannot be retrofitted.
3 .3 Storage and transport
Your instrument was protected by packaging during transport.
Its capacity to handle normal loads during transport is assured
by a test according to DIN EN 24180.
The packaging of standard instruments consists of environ-
ment-friendly, recyclable cardboard. For special versions, PE
foam or PE foil is also used. Dispose of the packaging material
via specialised recycling companies.
l
Storage and transport temperature see "Supplement -
Technical data - Ambient conditions"
l
Relative humidity 20 … 85 %
Area of application
Packaging
Storage and transport
temperature
6 VEGAFLEX - External housing
Product description
34106
-EN
-080227