VEGA VEGAFLEX 63 Profibus PA - Manual (Page 38)

l FX-E.60PX (X = without approvals)
l FX-E.60PA (A = approvals CA, DA according to product list)
l FX-E.60PC (C = approvals XM, CX, CM, CK, GX according to
product list)
8.4 Software update
The software version of VEGAFLEX 63 can be determined as follows:
l on the type label of the electronics
l via the indicating and adjustment module
l via PACTware
You can view all software histories on our website www.vega.com.
Make use of this advantage and get registered for update information
via e-mail.
The following components are required to update the sensor software:
l Sensor
l Voltage supply
l VEGACONNECT
l PC with PACTware
l Current sensor software as file
At "www.vega.com/downloads" go to "Software". Select under "plics
instruments and sensors" the suitable instrument series. Load the zip
file via the right mouse key with "Save target as" e.g. on the desktop of
your PC. Extract all files available in the zip file, e.g. to the desktop.
Connect the sensor to power supply and provide connection from PC
to the instrument via VEGACONNECT. Start PACTware and provide
connection to the sensor, e.g. via the VEGA project assistant. Close
the parameter window of the sensor, as far as open.
Go in the PACTware menu bar to "Instrument data", "Additional
functions" and "Update instrument software".
PACTware now checks the actual hardware and software version of
the sensor and displays the data. This procedure lasts approx. 60 s.
Push the button "Update software" and select the previously
extracted hex file. Then the software update can be started. The
additional files are installed automatically. Depending on the sensor,
this procedure can last approximately 1 h.
8.5 Instrument repair
If a repair is necessary, please proceed as follows:
You can download a return form (23 KB) from our Internet homepage
www.vega.com under: "Downloads - Forms and certificates - Repair
form".
Load sensor software to
PC
Prepare update
Load software into sen-
sor
38 VEGAFLEX 63 • Profibus PA
8 Maintenance and fault rectification
31843
-EN
-100426