VEGA VEGAWELL 51 4 … 20 mA - Manual (Page 18)

T
ake note of the corresponding installation regulations for Ex
applications.
5 .2 Connection procedure
P
roceed as follows:
1 W ire the connection cable up to the connection compart-
ment. The bending radius must be at least 25 mm. 2)
2 C
onnect the wire ends to the screw terminals according to
the wiring plan
P roceed as follows:
1 S nap VEGABOX 02 onto the carrier rail or screw it to the
mounting plate
2 L
oosen the cover screws and remove the cover
3 S
hift cable through the cable gland into VEGABOX 01 B
4 L oosen the screws with a screwdriver
5 I nsert the wire ends into the open terminals according to
the wiring plan
6 T
ighten the screws with a screwdriver
7 C
heck the hold of the wires in the terminals by lightly
pulling on them
8 T
ighten the compression nut of the cable entry. The seal
ring must completely encircle the cable
9 C onnect the supply cable according to steps 3 to 8
10 S crew the housing cover on
T
he electrical connection is finished.
2) T he connection cable is already preconfectioned. After shortening the ca-
ble, fasten the type plate with support again to the cable.
Select connec-
tion cable for Ex
applications
Direct connection
Connection via
VEGABOX 02
18 VEGAWELL 51 • 4 … 20 mA
C onnecting to power supply
32465
-EN
-080604