VEGA VEGASON 65 Profibus PA - Manual (Page 17)

5 Plug the connection head to the transducer tube. Do not squeeze
any cables. The cylinder is in the correct position, if the lower
notch (2) of the transducer tube is no longer visible
1
2
3
4
Fig. 8: Mounting - Version D
1
Groove for locking the connection head
2 Notch
3 Hexagon nut SW 46
4 Terminal screws, connection head (hexagon spanner - size 4)
6 Tighten the screws (4) on the cylinder moderately with an Allen
wrench (size 4)
7 Rotate the connection head in such a way that the cable entry
points downwards (moisture can drain off). Fasten the cylinder
with screws (4); torque max. 5 Nm
8 Insert the plug at the end of the transducer cable into the socket on
the remote electronics
1
2 3
Fig. 9: Plug connector between transducer and socket of electronics housing
1
Socket electronics housing
2 Plug connector
3 Connection piece, transducer tube
VEGASON 65 • Profibus PA 17
4 Mounting
28788
-
EN
-081127