VEGA VEGASON 65 4 … 20 mA_HART four-wire User Manual

Page 35

n this menu item you can enter an unambiguous designation for the

sensor, e.g. the measurement loop name or the tank or product
designation. In digital systems and in the documentation of larger
plants, a singular designation should be entered for exact identiﬁcation
of individual measuring sites.

ensor-TAG

Sensor

ith this menu item, the Basic adjustment is ﬁnished and you can now

jump to the main menu with the [ESC] key.

igh sockets or vessel installations, such as e. g. struts or agitators as

well as buildup and weld joints on the vessel walls cause interfering
reﬂections which can impair the measurement. A false echo storage
detects and marks these false echoes, so that they are no longer taken
into account for the level measurement. A false echo memory should
be created with low level so that all potential interfering reﬂections will
be detected.

ating out of false signals

hange now?

roceed as follows:

ove from the measured value display to the main menu by

pushing [OK].

elect the menu item "Service" with [->] and conﬁrm with [OK].

ow the menu item "False signal suppression" is displayed.

onﬁrm "False signal suppression - Change now" with [OK] and

select in the below menu "Create new". Enter the actual distance
from the sensor to the product surface. All false signals in this area
are detected by the sensor and saved after conﬁrming with [OK].

Note:
C

heck the distance to the product surface, because if an incorrect (too

large) value is entered, the existing level will be saved as false signal.
T

he ﬁlling level would then no longer be detectable in this area.

he menu item "Extended setting" oﬀers the possibility to optimise

VEGASON

for applications in which the level changes very quickly.

or this reason, select the function "Quick level change > 1 m/min.".

xtended setting

quick level change > 1 m/min.

Sensor-TAG

Gating out of false sig-
nals

Extended setting/Quick
level change

VEGASON

65 • 4 … 20

mA/HART four-wire

6 S

et up with the indicating and adjustment module PLICSCOM

28782

-081127