VEGA VEGASON 65 4 … 20 mA_HART four-wire - Manual (Page 33)

0.00 %
=
5.000 m(d)
4.000 m(d)
3 P repare the % value for editing with [OK] and set the cursor to the
requested position with [->]. Set the requested percentage value
with [+] and save with [OK]. The cursor jumps now to the distance
value.
4 E nter the suitable distance value in m for the empty vessel (e.g.
distance from the sensor to the vessel bottom) corresponding to
the percentage value.
5 S ave the settings with [OK] and move to "Max. adjustment" with [-
>
] .
P roceed as follows:
M ax. adjustment
100.00 %
=
1.000 m(d)
2.000 m(d)
1 P repare the % value for editing with [OK] and set the cursor to the
requested position with [->]. Set the requested percentage value
with [+] and save with [OK]. The cursor jumps now to the distance
value.
2 E nter the appropriate distance value in m (corresponding to the
percentage value) for the full vessel. Keep in mind that the max.
level must lie below the dead band.
3 S ave the settings with [OK] and move to "Medium selection" with
[->] .
E ach product has different reflective properties. In addition, there are
various interfering factors which have to be taken into account:
agitated product surfaces and foam generation (with liquids); dust
generation, material cones and echoes from the vessel wall (with
solids). To adapt the sensor to these different conditions, you should
fi
rst select "Liquid" or "Solid".
M edium
Liquid
W ith solids, you can also choose between "Powder/Dust", "Granular/
Pellets" or "Ballast/Pebbels".
T hrough this additional selection, the sensor is adapted perfectly to the
product and measurement reliability, particularly in products with bad
reflective properties, is considerably increased.
Carrying out max. ad-
justment
Medium selection
VEGASON 65 • 4 … 20 mA/HART four-wire 33
6 S et up with the indicating and adjustment module PLICSCOM
28782
-
EN
-081127