VEGA VEGACAP 63 - contactless electronic switch - Manual (Page 22)

22
6 Setup
VEGACAP 63 • - contactless electronic switch
30009-EN-130916
5. Turn the potentiometer (1) very slowly clockwise until the control
lamp (6) lights red. If the control lamp does not light red, set the
meas. range selection switch (2) to the next higher stage and
repeat the setting with the potentiometer (1) until the control lamp
lights red.
The measuring system is now ready for operation.
6.3 Function chart
The following chart provides an overview of the switching conditions
depending on the set mode and the level.
Level Switching status Control lamp
Mode max.
Overflow protec-
tion 2 1
Switch closed Green
Mode max.
Overflow protec-
tion
2 1
Switch open Red
Mode min.
Dry run protection
2 1
Switch closed Green
Mode min.
Dry run protection
2 1
Switch open Red
Failure of the sup-
ply voltage
(min./max. mode)
any
2 1
Switch open
Fault any
2 1
Switch open flashes red