VEGA VEGAVIB 66 - two-wire - Manual (Page 11)

4 Mounting
4.1 General
In general, VEGAVIB 66 can be mounted in any position. The
instrument must be mounted in such a way that the vibrating
element is at the height of the requested switching point.
Use the recommended cables (see chapter "Connecting to
power supply") and tighten the cable gland.
You can give your VEGAVIB 66 additional protection against
moisture penetration by leading the connection cable down-
ward in front of the cable entry. Rain and condensation water
can thus drain off. This applies mainly to mounting outdoors, in
areas where moisture is expected (e.g. by cleaning processes)
or on cooled or heated vessels.
Fig. 2: Measures against moisture penetration
Do not hold VEGAVIB 66 on the vibrating element. Especially
with flange and tube versions, the sensor can be damaged by
the weight of the instrument.
Remove the protective cover just before mounting.
The process fitting must be sealed if there is gauge or low
pressure in the vessel. Before use, check if the seal material is
resistant against the measured product and the process
temperature.
The max. permissible pressure is stated in the "Technical
data" in the "Supplement" or on the type label of the sensor.
The vibrating level switch is a measuring instrument and must
be treated accordingly. Bending the vibrating element will
destroy the instrument.
Switching point
Moisture
Transport
Pressure/Vacuum
Handling
VEGAVIB 66 - with two-wire output 11
Mounting
29292
-EN
-060508