VEGA VEGAPULS 63 (≥ 2.0.0 - ≤ 3.8) 4 … 20 mA_HART - four-wire - Manual (Page 26)

6 Set up with the indicating and adjustment
module PLICSCOM
6 .1 Short description
T he indicating and adjustment module is used for measured value
display, adjustment and diagnosis. It can be mounted in the following
housing versions and instruments:
l A ll continuously measuring sensors in single as well as double
chamber housing (optionally in the electronics or connection
compartment)
l E xternal indicating and adjustment unit
Note:
Y
ou can find detailed information on the adjustment in the operating
instructions manual "Indicating and adjustment module".
6 .2 Insert indicating and adjustment module
T he indicating and adjustment module can be inserted into the sensor
and removed again at any time. It is not necessary to interrupt the
power supply.
P roceed as follows:
1 U nscrew the housing cover
2 P lace the indicating and adjustment module in the desired position
on the electronics (you can choose any one of four different
positions - each displaced by 90°)
3 P ress the indicating and adjustment module onto the electronics
and turn it to the right until it snaps in.
4 S crew housing cover with inspection window tightly back on
R emoval is carried out in reverse order.
T he indicating and adjustment module is powered by the sensor, an
additional connection is not necessary.
Function/Configuration
Mount/Dismount indica-
ting and adjustment mo-
dule
26 VEGAPULS 63 • 4 … 20 mA/HART - four-wire
6 S et up with the indicating and adjustment module PLICSCOM
28441
-EN
-120530