VEGA VEGABAR 75 4 … 20 mA_HART - Manual (Page 16)

5 .2 Connection procedure
P roceed as follows:
1 W
ire the connection cable up to the connection compart-
ment. The bending radius must be at least 25 mm. 2)
2 C onnect the wire ends to the screw terminals according to
the wiring plan
P roceed as follows:
1 S
nap connection housing onto the carrier rail or screw it to
the mounting plate
2 L oosen the cover screws and remove the cover
3 I nsert the cable through the cable entry into the connection
housing housing
4 L oosen the screws with a screwdriver
5 I nsert the wire ends into the open terminals according to
the wiring plan
6 T
ighten the screws with a screwdriver
7 C heck the hold of the wires in the terminals by lightly
pulling on them
8 T
ighten the compression nut of the cable entry. The seal
ring must completely encircle the cable
9 C onnect the supply cable according to steps 3 to 8
10 S crew the housing cover back on
T
he electrical connection is finished.
2) T he connection cable is already preconfectioned. After shortening the ca-
ble, fasten the type plate with support again to the cable.
Direct connection
Via VEGABOX 01 or VEGADIS
12
16 VEGABAR 75 - 4 … 20 mA/HART
C onnecting to power supply
28433
-EN
-070718