VTech DS6751_-2-3 Manual - Manual (Page 79)

Appendix
75
Screen messages
No line
There is no telephone line connected.
No message
There are no message in the answering system.
Not available
Another device is already in the directory, caller ID log, or accessing the
answering system; the cell line is not ready to use.
Number repeated
The telephone number you try to save is already stored in the directory.
Out of range or
no pwr at base
The telephone base has lost power, or the handset is out of range.
Phone
The handset is on a call.
Put in charger
The battery is very low. Put the handset in the telephone base or charger
for recharging.
Quiet mode off
The quiet mode is turned off.
Quiet mode on
The quiet mode is turned on.
Rec mem full
The answering system has no recording time left.
Registering...
The handset registration is in progress.
Ringer muted
The ringer is muted temporarily when the phone is ringing.
Ringer off The ringer is turned off.
Saved
Your selection has been saved.
Speaker
The speakerphone is in use.
To screen call
press [SELECT]
The system is recording a message. Press SELECT to screen a call on
a handset.
To register HS...
...see manual
Screen display on a non-registered handset.
Transferred
You have transferred an outside call to another device.
Unable to call
The handset is out of range while on a call.
Failed phone call (the telephone line is in use).
Failed intercom call (there are already two handsets being used).
XX missed calls
There are new calls in the caller ID log.
XX new messages
There are new messages in the answering system.
** Paging **
All system handsets are being paged.