VTech LS6426-3-4 Manual - Manual (Page 74)

Appendix
70
Energy-saving charging mode
When this mode is activated, all telephone functions, except handset battery charging, will be disabled.
To activate the energy-saving charging mode:
Unplug the telephone base power adapter from the power outlet. Make sure all handsets are
plugged with charged batteries before proceeding.
While you press and hold
/FIND HANDSET, plug the telephone base power adapter back to the
power outlet.
After about 20 seconds, when the
IN USE light starts flashing, release /FIND HANDSET and
then press it again within 2 seconds.
When the phone successfully enters the energy-saving charging mode, the IN USE light turns
off and all handsets display Put HS on BASE to register.
When the phone fails to enter this mode, repeat Step 1 through Step 3 above.
Note: The telephone base will be powered up as normal if you fail to press /FIND HANDSET within
2 seconds in Step 3.
To deactivate the energy-saving charging mode:
Unplug the telephone base power adapter from the power outlet, then plug it back in.
Then the telephone base is powered up as normal.
Register your handsets back to the telephone base. See page 59 for handset
registration instructions.
1.
2.
3.
1.
2.