VTech CS6319-2-3-4 Manual - Manual (Page 5)

ChArGe
light
Battery installation
Install the battery as shown below.
If the battery compartment cover is on the handset,
press on the indentation and slide the cover to remove.
Plug the battery connector securely into the socket
inside the handset battery compartment, matching the
color-coded label.
Place the battery with the label ThIS SIDe UP facing up
and the wires inside the battery compartment.
Align the cover flat against the battery compartment,
then slide it towards the center of the handset until it clicks
into place.
Charge the handset by placing it in the telephone base or
charger. The ChArGe light is on when the handset charges.
1.
2.
3.
4.
5.
1 3 2
4 5
If the handset will not be used for a long time, disconnect
and remove the battery to prevent possible leakage.
To purchase replacement batteries, visit our website at
www.vtechphones.com or call 1 (800) 595-9511. In
Canada, go to www.vtechcanada.com or dial
1 (800) 267-7377.
•
•
Getting started
2