VTech CS6319-2-3-4 Manual - Manual (Page 11)

Battery
It takes up to 16 hours for the battery to be fully charged. When it
is fully charged, you can expect the following performance:
Operation Operating time
While in handset use (talking*) Up to seven hours
While in speakerphone mode (talking*) Up to five hours
While not in use (standby**)
Up to seven days
*Operating times vary depending on your actual use and the age of
the battery.
**Handset is not charging or in use.
The battery needs charging when:
A new battery is installed in the handset.
The handset beeps.
A battery is properly installed and the screen is blank.
LOW BATTerY or PLACe IN ChArGer shows on the
handset screen.
CAUTION:
To reduce the risk of fire or injury, read and follow these instructions:
Use only the battery(ies) provided or equivalent. To order a
replacement, visit our website at www.vtechphones.com or call
1 (800) 595-9511. In Canada, go to www.vtechcanada.com or dial
1 (800) 267-7377.
Do not dispose of the battery(ies) in a fire. Check with local waste
management codes for special disposal instructions.
Do not open or mutilate the battery(ies). Released electrolyte is
corrosive and may cause burns or injury to the eyes or skin. The
electrolyte may be toxic if swallowed.
Exercise care in handling batteries in order not to create a short
circuit with conductive materials.
Charge the battery(ies) provided with or identified for use with this
product only in accordance with the instructions and limitations
specified in this manual.
Observe proper polarity orientation between the battery and
metallic contacts.
To prevent fire or shock hazard, do not expose this product to water
or any type of moisture.
•
•
•
•
•
•
•
•
•
•
•
Appendix
8