VTech SN6187 Abridged manual - Manual (Page 23)

Getting started
16
Getting started
Add and register a pendant
When first purchased, charge the pendant in the
pendant charger. You hear three beeps every
10 seconds when the pendant is not registered.
The new pendant should be charged without
interruption for at least 30 minutes before
registering it to the telephone base.
Make sure the pendant is out of the pendant
charger and turned on.
To register a pendant:
Press and hold /FIND HANDSET
at the side of the telephone
base until the IN USE light turns
solid red.
Put the pendant in the pendant
charger. The pendant
status light flashes red
and green to indicate the
registration is in progress.
The pendant beeps. Then
it is registered with the
telephone base. It takes up
to 60 seconds to complete
registration.
If registration fails, you hear an error tone. Start
again from Step 1 above.
1.
2.