VTech S2221 Manual - Manual (Page 29)

SIP petite 1-line - S2211
Telephone operation
Receive a call
The telephone rings, the IN USE light and the MESSSGE WAITING LED flash when there is an incoming call.
To answer a call:
Lift the corded handset from the telephone base. The
IN USE light illuminates when the phone line is in use.
Place a call
Lift the corded handset from the telephone base. Listen for a dial tone and then dial the desired number, or press a Speed Dial key to
dial a programmed number. The IN USE light illuminates when the phone line is in use.
End a call
Place the corded handset in the telephone base.
Volume
Listening volume and ringer volume can be adjusted at the telephone base.
To adjust the listening volume:
During a call, press
+/VOLUME or -/VOLUME to adjust the listening volume. The next call returns to the default listening volume.
To adjust the ringer volume:
At any time, slide the
RINGER VOL switch on the right side of the telephone base to adjust the ringer volume.
Message waiting indicator
When a voice message is received, the MESSAGE WAITING LED on the telephone base flashes.
Call waiting
When you hear a call waiting tone during a call, press FLASH on the telephone base to put your current call on hold and take the
new incoming call.
Press
FLASH or the switch hook rapidly at any time to switch back and forth between calls.
Mute
To mute the microphone:
During a call, press MUTE on the telephone base. The MUTE light turns on when the mute function is turned on. You can hear
the party on the other end but they cannot hear you.
Press
MUTE again to resume the conversation. The MUTE light turns off.
Hold
To place a call on hold:
During a call, press HOLD on the telephone base to place that call on hold.
To release the call from hold, lift the corded handset.
Transfer a call
During a call, press FLASH to put the current call on hold.
When you hear a dial tone, dial the number you want to transfer the call to.
When you hear the ringing tone or the call is answered, place the corded handset back in the telephone base. Then the call
is transferred.
Computer port
You can route your computer through the
COMPUTER port (RJ-45) on the side of the telephone base to get Internet access.
USB port
The
port on the side of the telephone base can be used for charging devices (up to 500mA @ 5V). Charging will be suspended
when there is an incoming call or the telephone is in use.
1.
2.
1.
2.
1.
2.
1.
2.
3.
26