beautypg.com

Sip petite corded 1-line/2-line - s2211/s2221, Sip petite 1-line/2-line - s2211/s2221, Installation – VTech S2221 Manual User Manual

Page 17

background image

14

Telephone base installation

The telephone can be adapted to desktop use or mount on a standard telephone wall plate.

Installation option - desktop position

Turn the telephone base over with the bottom side facing up. Connect the telephone line cord to the telephone base and route

along the wire duct.

Position the mounting bracket as shown. Insert the two small tabs of the mounting bracket into the lower slots on the telephone

base. Then press the large tab on the mounting bracket and firmly push it into the upper groove on the telephone base.

Install the telephone base as shown below. Then connect the coiled handset cord to the telephone base.

1.

2.

3.

Installation

SIP petite 1-line/2-line - S2211/S2221

Telephone line jack

Wire duct

Once installed, the telephone begins a four-step initialization and system registration process.

For

S2211: (1) The MUTE key and IN USE lights turn on and then go off. (2) The MUTE key flashes. (3) The MUTE key

stops flashing. (4) The

MESSAGE WAITING LED, MUTE and IN USE lights illuminate for 500ms when initialization and

system registration are successful.

If the system registration fails, the

IN USE key blinks twice every second. T

o reset, disconnect the Cat-5 network cable from

the network wall jack with Power over Ethernet (PoE) and connect it back again.
For

S2221: (1) The MUTE key and LINE 1 turn on and then go off. (2) The MUTE key flashes. (3) The MUTE key stops

flashing. (4) The

MESSAGE WAITIN

G LED, LINE 1, LINE 2, CONF and MUTE illuminate for 500ms when initialization and

system registration are successful.
If the system registration fails, the

LINE 1 key blinks twice every second. T

o reset, disconnect the Cat-5 network cable from

the network wall jack with Power over Ethernet (PoE) and connect it back again.

4.

Cat-5 network cable

Network wall jack with Power over Ethernet (PoE)

CAUTION:

Use only the supplied Cat-5 network cable. Cat-5 network cable is not designed for use in any other IT devices. Misuse of Cat-5 network cable on

your other IT devices shall be prohibited. To order a replacement, visit our website at www.vtechhotelphones.com or call 1-888-907-2007.