VTech S2221 Manual - Manual (Page 25)

SIP contemporary 1-line - S2210
Using the corded handset and the telephone base
The corded handset and the telephone base speakerphone cannot be used at the same time. However, calls can be switched
between the corded handset and the telephone base speakerphone.
Receive a call
The telephone rings and the LINE key flashes when there is an incoming call.
To answer a call using the corded handset:
Lift the corded handset from the telephone base. The
LINE key illuminates when the phone line is in use.
To answer a call using the telephone base speakerphone:
On the telephone base, press
LINE or /SPEAKER. The LINE key illuminates when the phone line is in use. The /SPEAKER key
illuminates when in speakerphone mode.
Place a call
On the telephone base, lift the corded handset, or press LINE or /SPEAKER. Listen for a dial tone and then dial the desired
number, or press a Speed Dial key to dial a programmed number. The LINE key illuminates when the phone line is in use. The
/SPEAKER key illuminates when in speakerphone mode.
End a call
Place the corded handset in the telephone base, or press LINE or /SPEAKER when in speakerphone mode.
Switch a call between the corded handset and the telephone base speakerphone
To switch a call from the corded handset to the telephone base speakerphone, press /SPEAKER on the telephone base, then
place the corded handset on the telephone base cradle.
To switch a call from the telephone base speakerphone to the corded handset currently on the telephone base cradle, lift the
corded handset from the telephone base cradle.
To switch a call from the telephone base speakerphone to the corded handset which is not on the telephone base cradle, press
/SPEAKER on the telephone base.
Volume
Listening volume and ringer volume can be adjusted at the telephone base.
To adjust the listening volume:
During a call, press
+/VOLUME or -/VOLUME to adjust the listening volume. The next call returns to the default listening volume.
To adjust the ringer volume:
When the telephone is idle, press
+/VOLUME or -/VOLUME to adjust the ringer volume.
Message waiting indicator
When a voice message is received, the MESSAGE WAITING LED on the telephone base flashes.
Call waiting
When you hear a call waiting tone during a call, press FLASH on the telephone base to put your current call on hold and take
the new incoming call.
Press
FLASH or the switch hook rapidly at any time to switch back and forth between calls.
Redial
The last dialed number is stored for 15 minutes.
To redial the last dialed number:
Lift the corded handset from the telephone base, or press
LINE or /SPEAKER. Listen for a dial tone. Then press REDIAL.
Mute
To mute the microphone:
During a call, press MUTE on the telephone base. The MUTE light turns on when the mute function is turned on. You can hear
the party on the other end but they cannot hear you.
Press
MUTE again to resume the conversation. The MUTE light turns off.
•
•
•
1.
2.
1.
2.
Telephone operation
22