VTech DM221-2 Manual - Manual (Page 9)

2
Getting started
Baby unit installation
You can power up the baby unit by connecting it to AC power.
Install the baby unit as shown below.
Make sure that the power outlet is not controlled by a wall switch. Bundle the
power adapter cord neatly with a twist tie.
The baby unit turns on when it is powered up.
Use only the power adapters supplied with this product. To order a
replacement, visit our website at www.babymonitors.vtech.com or call
1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call
1 (800) 267-7377.
The adapters are intended to be correctly oriented in a vertical or floor mount
position. The prongs are not designed to hold the plug in place if it is plugged
into a ceiling, under-the-table or cabinet outlet.
Make sure the unit and the power adapter cord are out of reach of children.
•
•
•
Baby unit
Power outlet not
controlled by a
wall switch
Power adapter
The POWER
light remains
on when the
baby unit is
turned on.