VTech LS6191_-13-15-16-17 Abridged manual - Manual (Page 2)

Telephone base installation
Install the telephone base as shown below.
Use only the power adapter and battery supplied with this product. To order a
replacement, visit our website at www.vtechphones.com or call (800) 595-95.
In Canada, go to www.vtechcanada.com or call (800) 267-7377.
Even if you do not subscribe to any conventional telephone service, you can still
use the cell line alone without plugging in a telephone line cord.
If you subscribe to telephone service from a cable company or a VoIP service
provider, contact your cable/VoIP service provider for more information.
•
•
•
Telephone wall jack Electrical outlet
(not controlled
by a wall switch)
Telephone base
power adapter
Telephone line cord
A DSL filter (not included) is
required if you have DSL
high-speed Internet service.
The DSL filter must be
plugged into the telephone
wall jack.
2
Battery Pack / Bloc-piles :
(2.4V Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery installation
Install the battery as shown below.
Insert the battery connector
securely into the socket as
shown below.
. Place the battery with the label
THIS SIDE UP facing up and the
wires inside the battery compartment.
2.
Slide the battery compartment cover
towards the center of the handset
until it clicks into place.
3. Place the handset on the telephone
base to charge.
.
Battery Pack / Bloc-piles :
(2.4V Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles :
(2.4V Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
displays
when charging.
2
BASE
10:01 AM 12/08
ANS ON 9
IMPORTANT:
Check for a dial tone by pressing
. If you hear a dial tone, the installation is successful.
If you do not hear a dial tone:
Make sure the installation procedures described above are properly done.
It may be a wiring problem. If you have changed your telephone service to digital service
from a cable company or a VoIP service provider, the telephone line may need to be
rewired to allow all existing telephone jacks to work. Contact your cable/VoIP service
provider for more information.
•
•