VTech LS6191_-13-15-16-17 Abridged manual - Manual (Page 11)

Message playback at the telephone base
Tap when the phone is not in use.
Options during playback:
Tap VOL+ or VOL- to adjust the speaker volume.
Press 2 to skip to the next message.
Press 4 to repeat the playing message. Press 4 twice to listen to the
previous message.
Press
3x to delete the playing message. The system advances to the
next message.
Tap
to stop.
Call intercept
If you want to talk to the person whose message is being recorded, press
, or on the cordless handset, or or on the telephone base.
Add and register a handset
The cordless handset provided with your phone system is already registered. Each
handset is assigned a number that displays on the handset. Additional handsets
registered to the telephone system are assigned numbers in the sequential order.
This telephone system accomodates up to five handsets.
You can add new handsets (
LS6001/LS6001-13/LS6001-15/LS6001-16/LS6001-17,
purchased seperately) to your telephone system. Each handset must be registered
with the telephone base before use. When first purchased and properly charged,
each expansion handset alternately displays To register HS... and ...see manual.
The new handset should be charged without interruption for at least 30 minutes
before registering it to the telephone base.
To register a handset:
At the bottom of the telephone base, press and hold
/ FIND HANDSET for about four seconds until it shows
Registering...
On the cordless handset, press then it shows
Registering... Both the telephone base and cordless
handset show Registered and you hear a beep when
the registration process completes. The registration
process takes about 60 seconds to complete.
Replace a handset
If you want to replace a handset or reassign the designated handset number of
a registered handset, you must deregister all handsets and then deregister each
handset individually.
To deregister all handsets:
Press and hold /FIND HANDSET at the bottom of the telephone base for about
0 seconds until the telephone base shows Registering... then De-register?
Immediately press /FIND HANDSET again. You hear a confirmation tone.
All handsets alternately show To register HS... and ...see manual. The
deregistration process takes about 0 seconds to complete.
Troubleshooting
If you have difficulty with your telephone, please try the suggestions below.
For customer service, visit our website at www.vtechphones.com or call
(800) 595-95. In Canada, go to www.vtechcanada.com or call (800) 267-7377.
I cannot add and connect my cell phone to the telephone base.
Make sure you have cellular coverage.
Make sure your cell phone is compatible with your LS6191. Check the Bluetooth
compatibility list at www.vtechphones.com.
Make sure the Bluetooth function of your cell phone is turned on. See the user’s
manual of your cell phone for more information.
Make sure that your Bluetooth cell phone is not connected to any other
Bluetooth device.
To connect your cell phone, make sure that your cell phone is connected and
active on the device list.
Remove VTech LS6191 from your cell phone’s handsfree device history list (see
the user’s manual of your cell phone for more information).
Carefully follow the pairing instructions on page and make sure that your cell
phone is not connected to any other Bluetooth device.
Turn off your cell phone, then turn it on again.
For some cell phones, you must authorize VTech LS6191 device in your cell
phone’s Bluetooth feature. See the user’s manual of your cell phone for
more information.
Manually connect your cell phone to VTech LS6191. Refer to the user’s manual
of your cell phone for more information.
Reset the telephone base. Unplug the unit’s electrical power. Wait for
approximately 5 seconds, then plug it back in. Repeat the above suggestions.
•
•
•
•
•
.
2.
.
2.
3.
•
•
•
•
•
•
•
•
•
•
•