VTech CS6124_-2-31 Manual - Manual (Page 6)

2
Getting started
Use only the power adapters supplied with this product.
The power adapters are intended to be correctly oriented in a vertical or floor mount
position. The prongs are not designed to hold the plug in place if it is plugged into a
ceiling, under-the-table or cabinet outlet.
•
•
Wall mounting (optional)
Your telephone comes ready for tabletop use.
To mount your telephone on the wall:
Position the top hole at the back of the
telephone base against the
top mounting stud [A].
Slide the telephone base
down on the mounting
studs [A] and [B] until it
locks into place.
1.
2.
Telephone base
[A]
[B]
Mounting
studs
Telephone base and charger installation
Install the telephone base and charger as shown below.
If you subscribe to digital subscriber line (DSL) high-speed Internet service through
your telephone line, you must install a DSL filter between the telephone line cord
and telephone wall jack. Contact your DSL service provider for more information
about DSL filter.
Telephone base
Telephone
line cord
Electrical outlet
(not controlled by
a wall switch)
Telephone
wall jack
A DSL filter (not
included) is required
if you have DSL
high-speed Internet
service
Telephone base
power adapter
Charger
Charger
adapter
CAUTION: If you subscribe to telephone service from a cable company or a VoIP
service provider, contact your cable/VoIP service provider for more information.