beautypg.com

Telephone base installation, Battery charging, Battery installation – VTech LS6195_-13-15-16-17 Abridged manual User Manual

Page 2

background image

Battery Pack / Bloc-piles :
(2.4V Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine

THIS SIDE UP / CE CÔTÉ VERS LE HAUT

Telephone base

Telephone base installation

Install the telephone base as shown below.

Use only the power adapter and battery supplied with this product. To order a

replacement, visit our website at www.vtechphones.com or call (800) 595-95.

In Canada, go to www.vtechcanada.com or call (800) 267-7377.

Battery charging

Once you have installed the battery, the screen indicates the battery status (see

the table below). For best performance, keep the handset in the telephone base

when not in use. The battery is fully charged after hours of continuous charging.

Battery indicators

Battery status

Action

The screen is blank, or

displays

Put in charger

and flashes.

The battery has no or very

little charge. The handset

cannot be used.

Charge without interruption

(at least 30 minutes).

The screen displays

Low battery and flashes.

The battery has enough

charge to be used for a

short time.

Charge without interruption

(about 30 minutes).

The screen displays

HANDSET 1.

The battery is charged.

To keep the battery charged,

place it in the telephone base

when not in use.

Battery installation

Install the battery as shown below.

Telephone wall jack

Plug the battery connector

securely into the socket.

.

Place the battery with the label

THIS SIDE UP facing up and the

wires inside the battery compartment.

2.

Slide the battery compartment cover

towards the center of the handset until

it clicks into place.

3.

Place the handset in the telephone

base to charge.

4.

CHARGE light

remains on

when charging.

Electrical outlet

(not controlled

by a wall switch)

Telephone base

power adapter

Telephone line cord

A DSL filter (not included) is

required if you have DSL

high-speed Internet service.
The DSL filter must be

plugged into the telephone

wall jack.

2

Battery Pack / Bloc-piles :
(2.4V Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine

THIS SIDE UP / CE CÔTÉ VERS LE HAUT

Battery Pack / Bloc-piles :
(2.4V Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine

THIS SIDE UP / CE CÔTÉ VERS LE HAUT