V-Tech DT16_D3AL Manual User Manual
Page 8

5.3 Date and Time Setting
5.4 Slave Address and Guard Unit
5.5 Restore to Default
1. Select
setup
item on main menu page to enter setup
page,then use ▲ / ▼ button to select
Advanced set...
item. A password will be asked before enter next sub
menu.the password is 2008, use ▲ / ▼ Button to
increase / decrease the value; use
/ Button to
select last/next digital. After inputing,press MENU
Button to confirm and enter the sub menu page.
2. Select
Date and Time Set...
item. Input date and
time by pressing the ▲ / ▼ Button to increase /
decrease the value and
/ Button to select last/
next digital,After finishing,press MENU Button to
confirm.
Time
Date 2 0 1 0 0 3 3 1
1 0 3 2
:
Slave Addr Set -- 0
Guard Unit Set -- 0
Date/Time Set...
Other Settings...
Information...
Exit
According to 5.3 , select
Information...
item, this item
will show the
hardware/software
version and voltage
information of the Monitor. Select
Restore to default
item
,then press MENU button. All settings will be restored
to default.(Note that the restore to default operation will
not change the time setting and the datas.)
Hardware ver 0302
Software ver 0168
Voltage 22.4V
Manufacture 00.0T
Restore to default
Exit
4
1. According to 5.3. The
Slave Addr Set
item is for the master and slave user code
setting, it is set by installer.
2.
Guard Unit Set:
if the item is set to
1
, the Monitor is assigned as a Guard Unit
Monitor, for normal users, it should be set to
0
.