Philips MONITOR SCD489 - Manual (Page 7)

8 I Room temperature below temperature set in menu
9 O ‘No connection between units’ message
10 { ‘Volume level’ message
11 S Message when lullaby is interrupted
D Travel bag
important
Read these instructions for use carefully before you use the appliance and save them for future
reference.
This baby monitor is intended as an aid. It is not a substitute for responsible and proper adult
supervision and should not be used as such.
Check if the voltage that is indicated on the adapter corresponds to the local mains voltage
before you connect the appliance.
Use and store the appliance at a temperature between 10°C and 0°C.
The appliance is suitable for mains voltages ranging from 0 to 0V.
Do not expose the baby monitor to extreme cold or heat or to direct sunlight.
Make sure the baby unit and the cord are always out of reach of the baby (at least 1 metre/
feet away).
Never place the baby unit inside the baby’s bed or playpen.
Never cover the baby monitor with a towel or blanket.
Never immerse any part of the baby monitor in water or any other liquid.
Never use the baby monitor in moist places or close to water.
Except for the battery compartments, do not open the housing of the baby unit and parent
unit in order to prevent electric shock.
Only use the adapter supplied to connect the baby unit to the mains.
Only use the charger supplied to charge the parent unit.
The adapters contain a transformer. Do not cut off the adapters to replace them with other
plugs, as this will cause a hazardous situation.
If the adapter of the baby unit is damaged, always have it replaced by one of the original type
in order to avoid a hazard.
If the charger or the adapter of the charger is damaged, always have the charger replaced by
one of the original type in order to avoid a hazard.
Always place batteries of the correct type in the baby monitor to avoid the risk of explosion.
Always use rechargeable batteries of the correct type for the parent unit.
Since continuous transmission is prohibited, you only hear your baby when it makes sounds.
Preparing for use
Baby unit
You can use the baby unit from the mains or on batteries. Even if you are going to use the unit from
the mains, we advise you to insert batteries. This guarantees automatic back-up in case of mains
failure.
Mains operation
1 Put the small plug in the baby unit and put the adapter in a wall socket. (Fig. )
Battery operation
The baby unit runs on four 1.5-volt R6 AA batteries (not included). We strongly advise you to use
Philips LR6 PowerLife batteries.
Make sure your hands and the unit are dry when you insert the batteries.
1 Turn the battery compartment to the left ( ¡ OPEN) with the palm of your hand. (Fig. )
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
EngliSh 7