Philips MONITOR SCD489 - Manual (Page 15)

Question Answer
Why does the parent unit
beep?
If the parent unit beeps while the LINK light blinks red and the
message ( O) is shown on the display, the connection
with the baby unit is lost. Move the parent unit closer to the baby
unit.
If the parent unit beeps, the LINK light blinks red and the battery
symbol on the display is empty, the batteries are running low.
Recharge the batteries.
If you have switched off the volume while the sound alert is on, the
parent unit beeps whenever the fifth sound level light starts to burn
orange because the baby unit has picked up a sound.
If you have set the room temperature on the parent unit and the
temperature alert is on, the parent unit beeps when the temperature
drops below the set level or below 7 °C or when the temperature
rises above the set level or above 33 °C.
Why does the appliance
produce a high-pitched
noise?
The units may be too close to each other. Make sure the parent unit
and the baby unit are at least 1 metre/3 feet away from each other.
The volume of the parent unit may be set too high. Decrease the
volume of the parent unit.
Why don’t I hear a sound/
Why can’t I hear my baby
cry?
The volume of the parent unit may be set too low or may be
switched off. Increase the volume of the parent unit.
The microphone sensitivity level may be set too. Set the microphone
sensitivity level to a higher level on the parent unit.
The baby unit and the parent unit may be out of range of each other.
Reduce the distance between the units.
Why does the parent unit
react too quickly to other
sounds?
The baby unit also picks up other sounds than those of your
baby. Move the baby unit closer to the baby (but observe the
minimum distance of 1 metre/3 feet).
The microphone sensitivity level may be set too high. Decrease the
microphone sensitivity level on the parent unit.
Why does the parent unit
react to baby’s crying
slowly?
The microphone sensitivity level on the parent unit may be set too
low. Increase the microphone sensitivity level on the parent unit.
Why do the batteries of
the baby unit run low
quickly?
The microphone sensitivity level may be set too high, which causes
the baby unit to transmit more often. Decrease the microphone
sensitivity level on the parent unit.
The volume on the baby unit may be set too high, which causes the
baby unit to consume a lot of energy. Decrease the volume on the
baby unit.
EngliSh 15