Hardware set, Hardware set hardware set----up up up up – Velleman PCSGU250 User Manual

Page 6

Hardware connection

Note

Note::::

---- At first time power

At first time power

At first time power----up, the oscilloscope will calibrate itself automatically.

up, the oscilloscope will calibrate itself automatically.

---- The

The

The actual screen

actual screen

actual screenssss can differ from the one shown in this manual

can differ from the one shown in this manual

can differ from the one shown in this manual.

Hardware Set

Hardware Set----up

(Close all programs before continuing)

USB driver install:

•

Connect your PCSGU250 unit to a free USB port

•

Follow the on screen driver installation procedure.

•

If Windows asks for Windows Update, select “not at this time”

•

Install the driver from a specific location, then browse on the CD and select the
folder D:\PCSGU250Driver

D:\PCSGU250Driver

D:\PCSGU250Driver. (press “next”)

•

If Windows indicate “has not passed Windows logo testing…” select “Continue
Anyway”.

•

After finishing, you can check the driver installation in the Device Manager list.

•

It is possible that the PC asks to “restart” for proper installation

Note:

Note: In case of malfunction, remove the USB driver in the control panel and
install the D:\PCSGU250Driver\PCSGU250Driver_WinUSB after reconnecting the
device.

Starting

Starting the software :

the software :

Locate the

Pc----Lab2000LT

Lab2000LT

software shortcuts (programs..

Pc-Lab2000LT

…)

Click the

icon to start the main program. “

loading, please wait

” should ap-

pear. Then the power LED goes ON on the unit. (*)

The main program automatically launches the Oscilloscope and generator
screen, which is shown on the next pages. Should you receive an error (ex. If no
unit is detected), disconnect and reconnect the USB cable and try again or, if you
want to access the demo mode (no unit is needed) :

- Click the

Options

menu, and select ‘

Hardware Setup’

> demo mode