Velleman К8074 User Manual
Page 7

7
IMPORTANT:
Construct the antenna coil as described to make sure it complies with the effective
R&TTE directive.
Wind the antenna using the included copper wire.
Remove the lacquer from one side of the wire with a knife so the solder will hold.
Wind the antenna using a Ø 5mm drill bit (NOT 4mm or 6mm).
Make 7 windings and elongate until the antenna is 10mm long (see fig. and picture on the packaging).
Solder the coil in place.
12. ASSEMBLING THE ANTENNA
Refer to the user manual *
* Download the user manual from www.vellemanprojects.com
13. TEST
Construction
10mm
5mm
7
IMPORTANT:
Construct the antenna coil as described to make sure it complies with the effective
R&TTE directive.
Wind the antenna using the included copper wire.
Remove the lacquer from one side of the wire with a knife so the solder will hold.
Wind the antenna using a Ø 5mm drill bit (NOT 4mm or 6mm).
Make 7 windings and elongate until the antenna is 10mm long (see fig. and picture on the packaging).
Solder the coil in place.
12. ASSEMBLING THE ANTENNA
Refer to the user manual *
* Download the user manual from www.vellemanprojects.com
13. TEST
Construction
10mm
5mm