2 input – Soft dB I-Track User guide User Manual
Page 16
14
6.2.2
Input
This interface shows the inputs configuration. This is where the user can perform microphone
calibration.
Sensor Info
The sensor info contains information such as manufacturer, model and serial number of
microphones in use. It also allows defining the input channel, the range and the sensitivity of each
microphone.
Microphone A
Microphone B
Phase
PI Residual
Microphone Spacer
See also other documents in the category Soft dB Audio:
- RAP-ONE - Quick User Guide (3 pages)
- Opus Suite Building Acoustics Module Airborne Sound Isolation between Rooms ASTM E 336_ISO 140-4 (40 pages)
- Piccolo Specsheet (2 pages)
- SmartSMS-CTL (2 pages)
- Alto6 Spec sheet (4 pages)
- Opus Suite Intensity Module (26 pages)
- Opus Suite SLM 4-Ch Module (70 pages)
- Concerto (4 pages)
- Opus Suite SLM & 3Vib Module (82 pages)
- Opus Suite Building Acoustics Module Reverberation Time ISO 3382 (36 pages)
- OBSI Software User Guide (26 pages)
- Piccolo User guide (21 pages)
- Alto6 User Guide (6 pages)
- SPM PLL User Guide (19 pages)
- Zen-Ten Spec sheet (4 pages)
- Opus Suite Building Vib Module (33 pages)
- Smart Piezo Drive User Guide (11 pages)
- SmartSMS brochure (8 pages)
- Mk3-HV1 Smart Piezo Drive Spec sheet (3 pages)
- SmartSMS-AMP (2 pages)
- Zen-Ten User guide (35 pages)
- Sound Intensity Mapping (7 pages)
- Migrating SR2 to SR2_NG (5 pages)
- Piccolo Quick User guide (2 pages)
- Tenor 24bits Data User Guide (59 pages)
- I-Track Specsheet (4 pages)
- Mk3-PLL Open Source SPM Controller & PLL Spec sheet (3 pages)
- SMS-STR Structure Speaker (1 page)
- SMS-25V-SURF Surface Speaker (1 page)
- Opus Suite Data Logger Module (62 pages)