Renata SA Article Safety Datasheet 3.7V Lithium-Polymer - Manual (Page 4)

Renata SA Tel. +41 (0)61 975 75 75 [email protected]
CH-4452 Itingen/Switzerland Fax. +41 (0)61 975 75 95 www.renata.com
The information and recommendations set forth are made in good faith and believed to be accurate as of the date of preparation. RENATA S.A. makes no warranty, expressed or implied, with
respect to this information and disclaims all liabilities from reliance on it.
Article Safety Data Sheet - Lithium Ion Polymer Batteries: 2013-09-27 Page 4 of 11
Section VI - Accidental Release
Steps to be taken in case material is released or spilled:
Wear appropriate personal protective equipment.
Isolate hazard area.
Keep unnecessary and unprotected personnel from entering.
Carefully recover spillages with appropriate ladle and/or clothe and transfer to a suitably labelled, sealable container
for safe disposal.
Wash the spillage area, neutralize with calcium hydroxide.
Wear suitable personal protection during removal of spillages.
Spontaneous fire and/or explosion can occur when material is released or spilled. Only use appropriate fire extinction
equipment.
Section VII - Handling and Storage
When used correctly, Lithium-ion Polymer Battery Pack provides a safe and dependable source of power.
However, if they are misused or abused, leakage, venting, or in extreme cases explosion and/or fire may
result.
Make sure to observe amongst others, following warnings.
Handling:
−
Do not insert batteries in reverse. Observe the polarity markings on battery and equipment
−
Do not short-circuit batteries
−
Do not overcharge batteries
−
Do not force discharge batteries
−
Do not mix batteries
−
Do not overheat batteries by exposure to high temperatures and direct sunlight.
−
Do not weld or solder directly to batteries
−
Do not dismantle batteries
−
Do not deform batteries
−
Do not dispose of batteries in fire
−
A battery with a damaged pouch should not be exposed to water
−
Do not allow children to replace batteries without adult supervision
−
Keep batteries out of the reach of children. In case of ingestion of a cell or battery, the person involved should
seek medical assistance promptly.
−
Equipment intended for use by children should have battery compartments which are tamper-proof
−
Do not encapsulate and/or modify batteries
−
Exhausted batteries should be immediately removed from equipment and disposed of (see section XIII)
−
When discarding batteries with solder tags, insulate the tags by wrapping them with tape, foil, etc.
Storage:
−
Store unused batteries in their original packaging and keep them away from metal objects which may short-
circuit them. Storing unpackaged cells together could result in cell shorting and heat build-up.
−
Store and display batteries in there original packaging in well ventilated, dry and cool conditions.
−
Avoid storing or display batteries in direct sun or in places where they get exposed to rain
−
Do not stack battery cartons on top of each other exceeding a specified height. The height is clearly dependent
on the strength of the packaging. As for general rule this height should not exceed 1.5 m for cardboard
packages or 3 m for wooden cases. The above recommendations are equally valid for storage conditions during