Omnimount PAN85PRO Manual - Manual (Page 5)

DOCUMENT NO : IA‐PANA85PRO_REV.A1
INSTALLATION AND ASSEMBLY INSTRUCTIONS
ALL DIMENSIONS ‐ MM (INCH)
MODEL : PANA85PRO
MAX LOAD CAPACITY : 300 LB (136.07 KG)
SETTING AND ADJUSTING TILT POSITION(S) / VERTICAL AND LATERAL ADJUSTMENT
WARNING
• Ensure that all adjustments are made with proper support of the panel at all times. No adjustments
should be made unless done by a qualified installation professional.
TILT ADJUSTMENT
• Remove the lower bolt shown in Fig. 1 (Factory installation is set at 0° tilt)
• NOTE: Retain all hardware for installation after tilt position is selected.
• Select the proper hole based on the desired tilt requirement.
• Insert the bolt back into position ‐ ensure that the tube from the panel bracket has remained in the
wall bracket and has not moved from the installation position.
• Secure all hardware.
Fig. 1