Omnimount PAN103PRO Manual - Manual (Page 6)

DOCUMENT NO : IA‐PANA103PRO_REV.A1
INSTALLATION AND ASSEMBLY INSTRUCTIONS
ALL DIMENSIONS ‐ MM (INCH)
MODEL : PANA103PRO
MAX LOAD CAPACITY : 500 LB (227 KG)
LATERAL ADJUSTMENT
• Ensure that the panel is properly supported during lateral adjustment.
• Lift the panel per Panasonic lifting requirements to remove the load from the installed components.
• The panel may be shifted from side to side for final positioning and then set back into the retaining
slots of the wall bracket.
VERTICAL ADJUSTMENT
• NOTE : Vertical adjustment should only be done by a qualified installation professional.
• NOTE : Factory installation is preset to the lowest (bottom) position.
• Vertical adjustment is intended to support the final leveling process of the installation and should not
be used in any other installation manner.
• Locate the vertical adjustment fastener on top of each installation wall bracket as shown in Fig. 2
• The bolt may be used to either raise and/or lower the vertical position for each wall bracket as needed
to level.