Omnimount PAN103PRO Manual - Manual (Page 3)

DOCUMENT NO : IA‐PANA103PRO_REV.A1
INSTALLATION AND ASSEMBLY INSTRUCTIONS
ALL DIMENSIONS ‐ MM (INCH)
MODEL : PANA103PRO
MAX LOAD CAPACITY : 500 LB (227 KG)
INSTALLATION TO THE WALL
WARNING
• Installer must verify that the supporting surface will safely support four (4) times the combined weight
of all attached equipment (wall mount) and hardware along with panel.
• Mount is only meant for surface mounting to a wall. For recessed mounting or any other mounting
please contact Omnimount Customer Service.
• Use ½” x 3 ½” Hex Head Lag Screws (H) and ½” Flat Washers (F) to attach Wall Brackets (A & B) to wall
in eight (8) places per Wall Bracket.
• Distance between inside edges of Wall Brackets must be 46" (1167mm) and Wall Brackets must be
level and square to one another.
CAUTION
• If Wall Brackets are not level and square, mount may not function properly.
• If using custom fasteners to attach Wall Brackets to wall be sure that fasteners can support the
combined weight of all attached equipment including wall mount and panel.
INSTALLATION TO THE PANEL