Ohaus NAVIGATOR NVT Rechargeable Battery Manual multi - Manual (Page 4)

Navigator Rechargeable Battery EN-2
6. Install the Recharge Circuit Board.
• Align the 8-pin connector and the PCB edges as shown in the picture.
• Press the circuit board down until the pins are fully engaged and the circuit board is sitting
on the mounting areas.
7. Position the battery and route the wires as shown in the picture above.
8. Re-install the battery compartment cover.
9. Connect the adapter to the Input Jack and to the proper AC supply.
Connect the AC Adapter plug to the
input jack.
Connect AC Adapter to the
proper AC supply.
OPERATION
The balance can be used on AC power immediately after the battery is installed. Allow the battery to
charge for 12 hours before using the balance on battery power.
While under rechargeable battery operation the Battery Icon will be lit. When the AC Adapter is
charging the battery icons will blink. Once the battery icon stops blinking the battery is fully charged.
When there is approximately 30 minutes of power remaining the battery icon will blink on/off every
0.5s. When the shutoff voltage is reached the display will alternately flash
Batt and LowJ for 15
seconds then the balance will shut down. The balance will not power up if the shutdown level voltage
is detected.
Input Jack
Battery
Cover